Train Wreck
  • Dremel Tool Turnout Jig

    Post 6 from my old blog - building hand made turnouts:

    As mentioned in my last post, I have discovered that a Dremel type moto-tool makes an excellent point shaping tool for constructing model railroad turnouts. Combined with the simple jig below I found the process to be much easier and faster than the traditional filing method.

    Here is a picture of the completed unit:

    Full Jig

    The idea is that rail is placed upside down between 2 aluminium strips that secure it tightly. This holder is then mounted on a slide that moves past the Dremel tool. The holder can swivel to create different angles. I use No. 409 cut off disks to cut and shape the rails. Points, stock rail notches and frogs can all be made with this jig. (Read more)

  • Turnouts 4 and 5

    Post 5 from my old blog - building hand made turnouts:

    A few days after that router episode I hit on the idea of using my Dremel Tool to grind the turnout points. I probably would have thought of it earlier but I only just got the Dremel for Christmas and wasn’t really up to speed on it uses. I quickly grabbed a short piece of rail, put it in a vice and stuck a No. 409 grinding disk into the Dremel. Success! Time to make another jig!

    I also decided to take the plunge and buy some supplies to build proper turnouts and ordered some MicroEngineering Code 55 rail and flextrack, as well as some PC board ties for sleepers, and some track gauges.

    While waiting for the new rail to arrive I practiced making turnouts with the new turnout grinding jig - which worked rather well. A lot less stressful and quite quick too. I managed to cut the pieces for turnout number five in about half an hour and with practice I am sure this will get better.

    When I get the time I will post a step by step guide of how I make my turnouts and some of the tricks I have learned. There are plenty of websites that show how to do it and my method is really just a variation on this. But did I mention my grinding jig works ‘great’!

  • A Turnout Jig

    Post 4 from my old blog - building hand made turnouts:

    After building 3 turnouts I have been thinking a bit on how to speed up their construction. By far the slowest - and hardest - part is filing the 2 switch rail points and a corresponding notch on the stock rails. It’s also quite stressful and easy to mess up.

    My first idea was to create some sort of jig and use a wood router to grind the rail to a point. This might seem strange but I have accidentally routed straight through a nail while cutting slots in wood on several occasions without much ill effect to the router bit, so it seemed quite a reasonable idea at the time :-) (Read more)